Hydramatic service kit

Driveline (including transmissions, differentials, tailshafts) discussion.

Hydramatic service kit

by army02strong » Wed May 20, 2020 6:02 pm

Hi, I'm new to this forum stuff.
Does anyone know where to get a service kit to suit a Hydramatic ?
 
Posts: 6
Joined: Wed May 20, 2020 4:49 pm

Re: Hydramatic service kit

by Carpet56 » Wed May 20, 2020 9:11 pm

Welcome to the forum. I dont know where you live but i had my hydramatic recoed in toowoomba qld by Gilroys Automatics. Even then i had to get the flex plate and torus input shaft rebuilt by a chap in the blue mts of nsw.
Regards Glenn
There is always light at the end of the tunnel,if not turn around it's a cave.
 
Posts: 51
Joined: Sun Jan 07, 2018 11:26 am
Location: Toowoomba

Re: Hydramatic service kit

by army02strong » Thu May 21, 2020 4:09 pm

Thanks Glenn, Im located in regional SA and have also asked a few local car club members.
The Prem hasn't been driven since '88 so needs some TLC to be driven again, oh and the motor and trans to be installed first :)
 
Posts: 6
Joined: Wed May 20, 2020 4:49 pm

Re: Hydramatic service kit

by Harv » Fri May 22, 2020 8:54 am

You can buy service kits from the US for hydramatics. They were referred to as the Slim Jim box, with the EK's using the Model 5. You can get the service kits from eBay for the Model 10, and suspect they fit Model 5...

https://www.ebay.com.au/itm/ROTO-10-SLI ... SwHnFVtY58

... but the prices are horrible. Some places (from memory Repco) were also importing them, though selling at a similar price. I imported a box of 50 filters a few years back, and sold them off at cost. It was about $70 each for the filter, gasket and o-ring. Sadly I don't have any left other than the ones I gave Dad for the EH Prem.

Cheers,
Harv
 
Posts: 475
Joined: Sun May 04, 2014 7:52 am

Re: Hydramatic service kit

by army02strong » Mon May 25, 2020 9:30 pm

Thanks for the extra information Harv.
Always good when you learn something new about your project.
The forum information on some of the older posts is great to read and had some helpful tips for my resto
Cheers
Steve
 
Posts: 6
Joined: Wed May 20, 2020 4:49 pm


Who is online
Users browsing this forum: No registered users and 1 guest