Van Gearbox Mount

Driveline (including transmissions, differentials, tailshafts) discussion.

Van Gearbox Mount

by EJ_VE_EH » Mon Oct 05, 2015 6:03 pm

I just changed the gearbox mount on my completely stock Van (149 with crashbox).
The new mount was significantly higher than the one that came out of it.........about 20mm.
I'm thinking that the original one has collapsed, but I'm not sure.

The one I put in is the same as this one:
mount.png (86.16 KiB) Viewed 4857 times

One of the online vendors sells these type of mount, but excludes EH vans and utes. See here: ... x-m/EM1115

I can't imagine they're different between sedans, wagons utes and vans.
I am slightly worried that the gearbox is up too high now.

Can anyone shed some light on this ?
Posts: 39
Joined: Sun Aug 16, 2015 8:36 pm

Re: Van Gearbox Mount

by utility8 » Mon Oct 05, 2015 9:40 pm

That one should be OK. The height variation, given it is a completely stock car, will not be an issue.
User avatar
Posts: 2647
Joined: Tue Mar 11, 2014 6:17 pm

Re: Van Gearbox Mount

by EJ_VE_EH » Tue Oct 06, 2015 12:09 am

Thanks for your quick response.
It bolted in fine, and it seems to drive fine.
Here's a picture of the mount I removed:
MOUNT2.png (227.65 KiB) Viewed 4848 times

As you can see, it's almost flat on top. I can't find any mounts that look like this, so I'm guessing that it's compressed/collapsed.

I did think that the increased angle of the tailshaft might cause an issue, but it seems OK.
Thanks again.
Posts: 39
Joined: Sun Aug 16, 2015 8:36 pm

Who is online
Users browsing this forum: No registered users and 2 guests